When selecting a pump, first confirm the fluid viscosity and required displacement per revolution, then match the motor speed and reduction ratio to avoid prolonged operation outside the efficient range.
When selecting a pump, first confirm the fluid viscosity and required displacement per revolution, then match the motor speed and reduction ratio to avoid prolonged operation outside the efficient range.
In precision fluid metering, displacement, accuracy, and fluid characteristics are interdependent. First determine the single-revolution displacement, then set the speed, and finally verify material and sealing with the actual fluid—getting this sequence wrong almost always leads to rework.
Processes typically specify a flow rate range rather than a single point. When converting this range to single-revolution displacement, allow room for adjustable speed: a common practice is to operate at 30%–70% of rated speed. This avoids amplification of low-speed pulsations while preventing prolonged operation near the upper limit.
Taking common gear metering pumps as an example, displacements cover 0.05–200 CC/r with speeds of 10–100 r/min. Depending on conditions, choose a single pump or two in parallel. Small-displacement pumps run at higher speeds with lower pulsation but faster wear; large-displacement pumps last longer at lower speeds but exhibit reduced linearity at low flow rates.
The nominal accuracy of ±0.5% refers to repeatability under calibrated conditions. The overall system accuracy also depends on pipeline pressure differential, fluid temperature, drive motor speed stability, and the presence of closed-loop control. Empirically, open-loop systems should evaluate pump accuracy, motor speed accuracy, and pipeline backpressure fluctuations collectively.
When pressure differentials exceed 0.2 MPa, consider installing pressure stabilization or bypass lines.
For fluids whose viscosity changes significantly with temperature, implement temperature control or perform segmented calibration by temperature.
For dual-component applications with strict mixing ratios, synchronize pumps A and B and use flow rate closed-loop control.
Material selection prioritizes media compatibility and abrasiveness: tool steel for general service; 440C or high-speed steel for highly abrasive or hard particles; Stellite overlay for high solid content and severe wear. Seals vary according to temperature and cleanliness requirements—oil seals plus PTFE packing suit typical colloids, while gland packing plus magnetic seals are suitable for high-temperature, volatile, or zero-leakage applications.
Regarding temperature, normal operating media are below 200℃, with high-temperature colloids reaching up to 350℃; pressures should be below 0.2 MPa at the inlet and 8 MPa at the outlet per import guidelines—exceeding these limits requires recalculating shaft seal and bearing life.
Finally, remember that prototype validation is more reliable than parameter sheets. Running a real medium at actual temperature and backpressure for 8 hours continuously saves more time than armchair selection based solely on datasheets.