Wear-Resistant Materials

Lithium-Ion Battery Slurry Transport: Selection of Wear-Resistant Materials, Cleaning, and Maintenance

Slurries have high solid content and strong abrasiveness; pump body and gear materials, sealing types, and online cleaning methods must be determined together.

齿轮计量泵选型

Lithium battery slurry has a high solids content and hard particles, resulting in much greater pump erosion than ordinary colloids. Material selection, sealing, and cleaning methods must be determined together during the equipment selection phase.

I. Slurry Erosiveness and Material Selection

After prolonged transport of solid-containing slurry, conventional tool steel experiences rapid wear at the gear end faces and side plates, leading to reduced flow rate and metering errors. For applications with high solids content or hard particles, it is recommended that gears and wetted parts be made of 440C stainless steel, high-speed steel, or Stellite overlay welding, while shaft sleeves should use silicon carbide or cemented carbide.

II. Seals and Cleaning Interfaces

  • Magnetic seals are preferred to prevent material buildup and dry friction at the shaft seal;

  • The pump body is equipped with a drain port and cleaning interface to support online circulating cleaning;

  • Flow paths should avoid dead corners to minimize slurry deposition and solidification;

  • Quick‑release clamps are installed on the inlet and outlet for easy disassembly, inspection, and spare part replacement.

III. Maintenance Cycles and Spare Parts

It is recommended to check flow deviation and outlet pressure weekly; if deviation exceeds 2%, schedule a disassembly inspection. Gears and shaft sleeves should be replaced in pairs to maintain proper end‑face clearance. Continuous production lines should keep a spare set of gears, shaft sleeves, and seals on hand to avoid downtime due to missing parts.

午腾测控微信公众号 Phone: 15301979852 (Mr. Liu) brave@wtckyb.com Leave a message online