Products and Selection

How do I select the displacement of a gear metering pump?

Displacement refers to the theoretical volume delivered per revolution of the pump shaft, measured in cc/r. Actual flow is calculated as "displacement × speed × volumetric efficiency," so larger displacement isn't always better; the key is ensuring the operating speed falls within the pump's optimal range.

Three Steps to Determine Displacement

  • Step 1: Calculate per-revolution requirement: Target flow (ml/min) ÷ Planned speed (r/min) = Required displacement. For example, for 60 ml/min at a planned 30 r/min, displacement is approximately 2 cc/r.
  • Step 2: Select the nearest standard displacement within the 0.05–200 cc/r range. It's preferable to choose slightly larger and adjust flow by reducing speed, rather than selecting a size that would require continuous full-speed operation.
  • Step 3: Verify volumetric efficiency: Higher fluid viscosity and greater outlet pressure increase internal leakage, reducing actual displacement below the theoretical value. For high-viscosity applications, adjust calculations using the manufacturer's viscosity-efficiency curve.

Recommended Speed Range

For standard models, an operating speed of 30–70 r/min is recommended to ensure stable metering while allowing adjustment tolerance as wear occurs. Below 10 r/min, pulsation becomes significant and motor performance at low speeds deteriorates; above 100 r/min, wear accelerates and cavitation may occur on the suction side. When extremely low flow rates are needed, use a large-displacement pump with a reduction gear ratio instead of running a small-displacement pump at high speed.

Match to Process Requirements

  • Low-pressure foaming, precision coating, microdispensing: Small-displacement models of 0.05–3 cc/r.
  • Hot-melt adhesives, fiber spinning, resin transfer: 5–50 cc/r, paired with low speeds and heated delivery lines.
  • High-flow circulation, filling: 50–200 cc/r; pay attention to inlet/outlet pipe sizes and suction head.
Still haven't solved your application issue? Send us details of the medium, temperature, flow rate, and pressure, and our engineers will help you calculate and select the appropriate equipment. Contact Technical Engineer Back to FAQs
午腾测控微信公众号 Phone: 15301979852 (Mr. Liu) brave@wtckyb.com Leave a message online